Author |
Message |
Aca Guest
|
Posted: Tue May 24, 2022 4:19 pm Post subject: Script after |
|
|
Script is executed when app is closed, does not metter if it is copied or not.
I think...not so good.
Thank you. |
|
Back to top |
|
|
TGRMN Software Site Admin
Joined: 10 Jan 2005 Posts: 8768
|
Posted: Tue May 24, 2022 11:27 pm Post subject: |
|
|
The end script is always executed. You can check VV_EXECUTED to see if profile was executed.
VV_EXECUTED = This variable is set to 1 if the execution method (backup, replication, synchronization) was started. It is set to 0 otherwise (e.g. a comparison only run or an error has happened before the execution method could start) _________________ --
TGRMN Software Support
http://www.tgrmn.com
http://www.compareandmerge.com |
|
Back to top |
|
|
Aca Guest
|
Posted: Wed May 25, 2022 12:17 pm Post subject: |
|
|
Thank you.
Maybe it is better to put a check box like: Execute only if copied... |
|
Back to top |
|
|
Alice
Joined: 29 Jan 2015 Posts: 281
|
Posted: Wed May 25, 2022 4:16 pm Post subject: |
|
|
I'd support this change too.
In my case if I click 'Show Compare' in VVEngine 2.2 the 'Run scripts after Execution' associated .bat file runs, but all I did was open the Profile to check the status of the Source and Destination....then clicked 'Close' (...not 'Execute'). |
|
Back to top |
|
|
|